This video tutorial explains how to pair a Godox AD200 flash with a Godox XPro trigger. The process begins by turning on the trigger and selecting Group A. The user then chooses between TTL and manual control, opting for manual. After confirming this choice, the flash unit is turned on, and the wireless selection button on the flash is used to navigate to the orange RX screen. It's crucial that the group setting on the flash matches the group on the trigger. The same applies to the channel, which the user sets to Channel 4. To add a second flash unit, the user presses and holds the ZM CH button on the trigger and uses the wheel to select the next group, Group B. The second flash unit (an AD200) is also set to Channel 4 by long-pressing the GR/CH button and using the wheel. On the second flash, the GR button is pressed to select Group B, and this is confirmed on the trigger. Finally, the user navigates to manual control on the trigger and sets the output strength for the second flash (e.g., 1/4 power). The tutorial concludes by stating that with this setup, both flashes can be controlled independently.

Julian Krakow

Good day to pair the Godo slash with Godox XPR trigger.

Turn on the trigger and choose group A. Press mode button and choose between TTL and manual control. I choose manual control. Press set to confirm your choice.

Turn on your flash and press Wireless selection button on the right to navigate to Orange RX screen. Make sure the group on your flash matches the group on your trigger. The same goes for the channel. I choose Channel 4.

To change the channel on the trigger press and hold ZM CH button then use the wheel to add a second flash unit to your Godox X Pro trigger. Again make sure that the both the trigger and the flash are on the same channel. In my case it's Channel 4.

On the AD200 unit long press GRCH button and use the wheel to change the channel. Press set then choose the next available group on your trigger in my case Group B and press GR button on the second flash and choose Group B. Press set to confirm it on your trigger.

Press mode and navigate to manual control. Change the output to your chosen strength for example 1/4. Press set and now you can control both flashes independently.

Thank you for watching.

How to pair multiple flashes with GODOX XPro trigger. #godox #ad200pro

good day to pair the godo slash with
godox XPR trigger turn on the trigger
and choose group a press mode button and
choose between TTL and manual control I
choose manual control press set to
confirm your
choice turn on your flash and press
Wireless selection button on the right
to navigate to Orange RX
screen make sure the group on your flash
matches the group on your
trigger the same goes for the channel I
choose Channel
4 to change the channel on the trigger
press and hold ZM CH button then use the
wheel to add a second Flash unit to your
godox X pro trigger again make sure that
the both the trigger and the Flash are
on the same channel in my case it's
Channel 4 on the ad200 unit long press
grch button and use the wheel to change
the
channel press
set then choose the next available group
on your trigger in my case Group B and
press gr button on the second flat
and choose Group B press set to confirm
it on your trigger press mode and
navigate to manual
control change the output to your chosen
strength for example 1/4 press set and
now you can control both flushes
independently thank you for
watching

Get Our Mobile App

How to pair multiple flashes with GODOX XPro trigger. #godox #ad200pro

Transcription